Turn off phone, remove microSD card and then turn on the phone.Use the command lsblk to check your devices: typically with the current kernel the microSD card is /dev/mmcblk0 and the eMMC is /dev/mmcblk2 but as always with dd be extremely cautious to get the devices correct. Flash the image file to eMMC using dd if= IMAGE.img of=/dev/ mmcblkX bs=1M status=progress conv=fsync where X is the number label of the eMMC (of the disk, not the partition!). Extract the image file if it is archived.Download the desired OS' image on the booted OS or transfer it to the microSD card.Flash an OS to the microSD card (and optionally resize the partition, see below).There are multiple methods to flash the eMMC as explained below. and follow the on-screen instructions.Īn operating system can also be booted from the internal memory of the PinePhone ("eMMC"). To do so, select the correct device in the left device selection, then click on the three dot menu and select Restore Disk Image. Gnome Disks can be used to flash the microSD card. This takes around 2.5 minutes to flash a 4 Gb file. Then run bmaptool with the correct device:ĭownload the IMAGE.xz and the IMAGE.bmap files, then run bmaptool copy -bmap IMAGE.bmap IMAGE.xz /dev/. Make sure to select the correct device using lsblk. Make sure you're NOT selecting /dev/sda1 or /dev/mmcblk0p1 as target. Note: The image needs to be written to the whole device, not to partition 1. Using the graphical application Balena Etcher to flash the microSD card is recommended for new or inexperienced users.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |